Your Cart (0)
Your cart is empty
Free shipping on orders over €99
3-flavour kit: 10% off automatically Build it
Made in Italy · Europe in 3–6 days
Your cart is empty
Groundbait, boilies, pellets, particles or artificial baits: how to add the flavour, how much to use and why it works at bait depth instead of rising to the surface.

How to use it
Choose how you fish: three steps, the dose and a practical tip. Works in fresh and salt water.
Immagine illustrativaThe flavour goes into the liquid, not onto the dry mix: that way it spreads evenly through the whole mix.
Dose10 ml per kg of dry mix
The dose is based on the dry mix, before wetting it.
Pour the flavour into the mixing water and stir well before adding it to the groundbait.
Wet in stages and let it absorb for a few minutes before making balls.
Tip. Start from the dose on the label and adjust it to water temperature and angling pressure.
Immagine illustrativaIf you roll your own: the flavour goes into the mix with the liquids, before the flours.
Dose10 ml per kg of dry mix
Eggs and liquids in a bowl: add the flavour here and stir.
Add the flours a little at a time until the paste is firm, then roll the boilies.
We recommend steam cooking, which keeps the properties of flours, stimulants and flavours unchanged.
Tip. Weigh the dry mix before you start: the dose is based on that.
Immagine illustrativaPellets, corn and particles need time to absorb the flavour: best to prepare them the night before.
Dose10 ml per kg
Put pellets or particles in a bucket with a lid or a resealable bag.
Spread it over the whole contents, 10 ml per kg.
Close, shake well and leave for a few hours, ideally overnight.
Tip. Only prepare what you use in the session and keep the bottle closed, in a cool, dry place.
Immagine illustrativaOn lures a few drops are enough: the flavour leaves a trail along the retrieve.
DoseA few drops per bait
A few drops straight on the lure, before casting.
You can leave soft plastics to soak in the flavour, in a sealed container.
After a few casts the water washes the flavour away: add a couple of drops.
Tip. Close the bottle tightly after use and keep it away from heat sources.
How the flavour works
Higher molecular weight aromatic components and a propylene glycol base denser than water, fresh and salt. In the water the flavour doesn't tend to rise to the surface: it spreads horizontally, at the same depth as your bait, creating a wide trail around the hookbait instead of a column going up.
↑Flavour lighter than water
Tends to rise in a column towards the surface and drifts away from the bait.
↔Energy Baits
Base denser than water: it stays at bait depth and spreads sideways.
¹ Density, miscibility and toxicity refer to the propylene glycol (CAS 57-55-6) used as the base, not to the finished product. For comparison: fresh water about 1.000 g/cm³, sea water about 1.025 g/cm³. ² 96-hour LC50: 51,600 mg/L on rainbow trout, 46,500–51,400 mg/L on Pimephales promelas. Source: OECD SIDS, Propylene Glycol (CAS 57-55-6).
Dosage guide
Set how much mix you prepare, how many sessions you fish and how many flavours you use: we'll tell you the ml you need and the best-value size for each flavour.
FAQ
Dosage, techniques, storage and base safety. If you can't find the answer, message us.
10 ml per kg of dry mix, as shown on the label. It applies to groundbait, pellets, particles and boilies.
Yes. We recommend steam cooking, which keeps the properties of flours, stimulants and flavours unchanged.
Yes, the flavours work in fresh and salt water. The base stays denser even than sea water, so it tends to work at bait depth.
Yes: a few drops on the lure, or soft plastics left to soak in the flavour.
12 months after opening, and always before the date on the label. Store in a cool, dry place, away from heat sources.
Propylene glycol and flavouring substances, as shown on the label. Made in Italy.
The base is propylene glycol, with low toxicity to fish: 96-hour LC50 above 46,000 mg/L (source: OECD SIDS). The figure refers to the base, not to the finished product.